Comparative Investigation of Yield and Quality of Carbon Nanotubes by Catalytic Conversion of Recycled Polypropylene and Polyethylene Plastics over Fe-Co-Mo/CaCO3 Based on Chemical Vapour Deposition

Résumé

Polypropylene (PP) and polyethylene (PE) plastic waste is accumulating in the environment and the oceans at an alarming rate.The current management methods, mostly landfilling and incineration, are becoming unsustainable.In this study, thermal catalytic conversion of waste PP and PE polymers into carbon nanotubes (CNTs) using a trimetallic catalyst prepared from the nitrate salts of iron, cobalt, and molybdenum supported with calcium carbonate was reported.The yield and quality of multi-walled carbon nanotubes (MWCNTs) produced were investigated.The findings showed a high graphitic value for the CNTs obtained from PP and PE, as corroborated by the d-spacing of XRD.The I D /I G ratio of CNTs synthesized from PP and PE as carbon sources were 0.6724 and 0.9028, respectively, which showed that CNT produced from PP has more ordered graphite.The functional groups present in the produced CNTs were determined via FITR analysis.The BET and Langmuir surface areas were found to be (6.834 and 70.468 m 2 /g) and (6.733 and 70.347 m 2 /g) for CNTs obtained from PP and PE respectively.The d-spacing was computed as 0.3425 nm and 0.3442 nm for CNTs made from PP and PE.These fall within the graphite's d-spacing at 0.335 nm.The TGA showed high percentage purity of 94.71 and 94.40% for the products obtained from PP and PE, respectively.The findings showed that recycled PP and PE could be good alternative carbon sources for CNT production.

Citer ce document

Accès au document

Texte intégral en lecture en ligne, réservé aux abonnés SPHAERO et aux membres de l'institution. Se connecter

Auteur(s)

Statistiques

Consultations : 1

Téléchargements : 0